Routing Protocol Configuration Command Set
Configuring VRRP
13-92 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.6.2 create
Use this command to create a VRRP session. Each Matrix Series Platinum routing module or
standalone device supports up to 1024 VRRP sessions. Up to four VRIDs can be associated with an
individual routing interface.
create vlan vlan-id vrid
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command disables the VRRP session:
no create vlan vlan-id vrid
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to create a VRRP session on VLAN 1 with a VRID of 1:
NOTE: This command must be executed to create an instance of VRRP on a routing
interface (VLAN) before any other VRRP settings can be configured.
vlan vlan-id Specifies the number of the VLAN on which to create a
VRRP session. This VLAN must be configured for IP
routing as described in Section 2.3.1.
vrid Specifies a unique Virtual Router ID (VRID) to associate
with the routing interface. The value of vrid can range from
1 to 255.
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#create vlan 1 1
To Next Page
Loading...
Need help?
General