Security Configuration Command Set
Configuring RADIUS
14-18 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Mode
Read-Write.
Command Defaults
None.
Examples
This example shows how to enable the RADIUS accounting client for authenticating with the
accounting server 1 at IP address 10.2.4.12, UDP authentication port 1800. As previously noted, the
“server secret” password entered here must match that already configured as the Read-Write (rw)
password on the RADIUS accounting server
:
This example shows how to set the RADIUS accounting timeout to 30 seconds on server 6:
This example shows how to set RADIUS accounting retries to 10 on server 6:
Matrix(rw)->set radius accounting server 1 10.2.4.12 1800
Server Secret:******
Retype Server Secret:******
Make This Entry Active (y/n)? y
Warning: rfc2138 recommends secret minimum length of 16
Matrix(rw)->set radius accounting timeout 30 6
Matrix(rw)->set radius accounting retries 10 6
To Next Page
Loading...
