Security Configuration Command Set
Configuring Policy-Based Routing
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-179
14.3.13.6 ip policy route-map
Use this command to assign a route map list to a routing interface.
ip policy route-map id-number
Syntax Description
Command Syntax of the “no” Form
The “no” form of un-assigns a route map list:
no ip policy route-map
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to assign route map 101 to VLAN 1:
id-number Specifies a route map ID number. Valid values are 100 -
199, and must match a value previously set using the
route-map command (Section 14.3.13.2).
NOTE: Only one route map list is allowed per
interface.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip policy route-map 101
To Next Page
Loading...
