General Configuration Command Set
Managing Configuration and Image Files
2-136 Matrix DFE-Platinum and Diamond Series Configuration Guide
Example
This example shows how to display the current non-default device configuration:
Matrix(rw)->show config
This command shows non-default configurations only.
Use 'show config all' to show both default and non-default
configurations.
........
..
begin
!
# ***** NON-DEFAULT CONFIGURATION *****
!
!
# cli
!
# console
!
# length
!
# logging
!
# port
set port disable fe.1.2-6
set port duplex fe.1.16 half
set port negotiation fe.2.1 disable
set port vlan fe.1.5 8
!
# system
set system location Office
end
To Next Page