Preparing the Device for Router Mode
Reviewing and Configuring Routing Modules
2-166 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.3.2.4 router
Use this command to enable routing mode on a module. This must be a module previously
configured for routing using the set router command as described in Section 2.3.2.2. Routing may
be configured on one or two modules.
router module
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable routing on module 1:
module Specifies the module on which to enable routing mode.
Matrix(rw)->router 1
To Next Page
Loading...
Need help?
General