Configuring LACP
Configuring Link Aggregation
4-118 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Defaults
• At least one parameter must be entered per port-string.
• If enable or disable are not specified, port(s) will be enabled with the LACP
parameters entered.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the actor admin key to 3555 for port ge.3.16:
padminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync |
lacpcollect |
lacpdist | lacpdef |
lacpexpire
Sets a port’s partner LACP administrative state. See
aadminstate for valid options.
enable (Optional) Enables LACPDU processing on this port.
disable (Optional) Disables LACPDU processing on this port.
Matrix(rw)->set port lacp ge.3.16 aadminkey 3555
To Next Page
Loading...
