Logging And Network Management Command Set
Monitoring Network Events and Status
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-27
11.2.2.1 history
Use this command to display the contents of the command history buffer. The command history
buffer includes all the switch commands entered up to a maximum of 50, as specified in the set
history command (Section 11.2.2.3).
history
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the contents of the command history buffer. It shows there are
five commands in the buffer:
Matrix(rw)->history
1 hist
2 show gvrp
3 show vlan
4 show igmp
5 show ip address
To Next Page
Loading...
