Logging And Network Management Command Set
Configuring RMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-87
Command Defaults
• If an action is not specified, packets will be accepted on filter matches.
• If not specified, control will be set to off.
• If onevent and offevent are not specified, none will be applied.
• If event status is not specified, ready will be applied.
• If a description is not specified, none will be applied.
• If owner is not specified, it will be set to monitor.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create an RMON channel entry:
Matrix(rw)->set rmon channel 54313 fe.2.12 accept failed control on
description “capture all”
To Next Page
Loading...
Need help?
General