General Configuration Command Set
Setting Basic Device Properties
2-70 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3.21 loop
Use this command to execute a command loop.
loop count [delay] [-r]
Syntax Description
Command Defaults
• If a delay is not specified, none will be set.
• If not specified, the cursor will not refresh.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to execute a command loop 10 times with a 30 second delay:
count Specifies the number of times to loop. A value of 0 will
make the command loop forever.
delay (Optional) Specifies the number of seconds to delay
between executions.
-r (Optional) Refreshes the cursor to the home position on
the screen.
Matrix(rw)->loop 10 30
To Next Page
Loading...
