IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-73
• (Optional) Specify a load balancing algorithm. predictor (Section 12.2.8.5)
• (Optional) Configure this server farm to use
sticky session persistence. (See “Sticky
Persistence Configuration Considerations” on
page 12-71 for more information.)
sticky (Section 12.2.8.6)
Configure a real server:
• (Optional) Display the real server configuration. show ip slb reals (Section 12.2.8.7)
• Enable a real server for service. inservice (Section 12.2.8.8)
• (Optional) Configure real server error handling. faildetect (Section 12.2.8.9)
• (Optional) Limit active connections to the real
server.
maxconns (Section 12.2.8.10)
• (Optional) Specify a weight load number for the
real server.
weight (Section 12.2.8.11)
Configure a virtual server:
• (Optional) Display the virtual server
configuration.
show ip slb vservers (Section 12.2.8.12)
• Specify a virtual server name. ip slb vserver (Section 12.2.8.13)
• Associate a virtual server with a server farm. serverfarm (Section 12.2.8.14)
• Configure a virtual server IP address (VIP). virtual (Section 12.2.8.15)
• Enable a virtual server for service. inservice (Section 12.2.8.16)
• (Optional) Restrict access to specific virtual
server clients.
client (Section 12.2.8.17)
• (Optional) Specify the type of session
persistence and timeout. Default is TCP. (See
“Session Persistence” on page 12-70 for more
information.)
persistence level (Section 12.2.8.18)
Table 12-8 LSNAT Configuration Task List and Commands (Continued)
Task Use these commands...
To Next Page
Loading...
