IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12-80 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.8.6 sticky
Use this command to configure sticky session persistence for this server farm. See “Sticky
Persistence Configuration Considerations” on page 12-71 for more information.
This command is used in conjunction with the persistence level sticky command described in
Section 12.2.8.18.
sticky
Syntax Description
None
Command Syntax of the “no” Form
The “no” form of this command removes this server farm using persistence sticky:
no sticky
Command Type
Router command.
Command Mode
SLB Server Farm Configuration mode: Matrix>Router1(config-slb-sfarm)#
Command Defaults
None
Example
This example shows how to set sticky persistence for the “lsnat” server farm:
Matrix>Router1(config)#ip slb serverfarm lsnat
Matrix>Router1(config-slb-sfarm)#sticky
To Next Page
Loading...
