IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-109
12.2.8.26 set router limits
Use this command to set LSNAT router limits.
set router limits [lsnat-bindings lsnat-bindings] | [lsnat-cache lsnat-cache] |
[lsnat-configs lsnat-configs]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
• If not specified, maximum bindings will be set to the default value of 5000.
• If not specified, cache size will be set to the default value of 1000.
• If not specified, maximum configs will be set to the default value of 50. That
is, up to 50 server farms, 50 virtual servers, and 50 direct access entries can be
NOTE: This command must be executed from the switch CLI.
lsnat-bindings
lsnat-bindings
(Optional) Sets the LSNAT maximum bindings limit.
lsnat-cache
lsnat-cache
(Optional) Sets the LSNAT cache size limit.
lsnat-configs
lsnat-configs
(Optional) Sets the LSNAT configuration limit for number
of server farms, virtual servers, direct access entries, real
servers, and client access entries.
The lsnat-configs value can range from 1 to 50. The number
specified will have the following effect:
• 1 to 50 server farms, virtual servers, and direct access
entries can be configured
• 10 to 500 real servers and client access entries can be
configured
To Next Page
Loading...
