Enterasys Matrix 2G4072-52 - Page 1074

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12-114 Matrix DFE-Platinum and Diamond Series Configuration Guide
Commands
The commands used to configure DHCP are listed below and described in the associated section as
shown:
• ip dhcp server (Section 12.2.9.1)
• ip local pool (Section 12.2.9.2)
• exclude (Section 12.2.9.3)
• ip dhcp ping packets (Section 12.2.9.4)
• ip dhcp ping timeout (Section 12.2.9.5)
• ip dhcp pool (Section 12.2.9.6)
• domain-name (Section 12.2.9.7)
• dns-server (Section 12.2.9.8)
• netbios-name-server (Section 12.2.9.9)
• netbios-node-type (Section 12.2.9.10)
• default-router (Section 12.2.9.11)
• bootfile (Section 12.2.9.12)
• next-server (Section 12.2.9.13)
• option (Section 12.2.9.14)
• lease (Section 12.2.9.15)
• host (Section 12.2.9.16)
DHCP Host
Configuration
Mode
Configure DHCP
host parameters.
Type
client-identifier and
the identifier, or
hardware-address
and an address from
any DHCP
configuration mode.
Matrix>Router1
(config-dhcp-host)#
Table 12-12 DHCP Command Modes (Continued)
Mode Usage Access Method Resulting Prompt