IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-125
12.2.9.10 netbios-node-type
Use this command to assign a NetBIOS node (server) type to DHCP clients.
netbios-node-type type
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command deletes the NetBIOS node type:
no netbios-node-type
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
None.
Example
This example shows how to specify hybrid as the NetBIOS node type for the “localpool” address
pool:
type Specifies the NetBIOS node type. Valid values and their
corresponding types are:
• h-node — hybrid (recommended)
• b-node — broadcast
• p-node — peer-to-peer
• m-mode — mixed
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#netbios-node type h-node
To Next Page
Loading...
