Routing Protocol Configuration Command Set
Configuring RIP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-15
13.2.2.10 key
Use this command to identify a RIP authentication key on a key chain.
key key-id
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the key from the key chain:
no key key-id
Command Type
Router command.
Command Mode
Key chain configuration: Matrix>Router1(config-keychain)#
Command Defaults
None.
Example
This example shows how to create authentication key 3 within the key chain called “md5key”:
NOTE: This release of the Matrix Series firmware supports only one key per key chain.
key-id Specifies an authentication number for a key. Valid number
are from 0 to 4294967295. Only one key is supported per
key chain in this Matrix Series release.
Matrix>Router1(config-router)#key chain md5key
Matrix>Router1(config-keychain)#key 3
To Next Page
Loading...
