Routing Protocol Configuration Command Set
Configuring RIP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-17
13.2.2.12 accept-lifetime
Use this command to specify the time period during which an authentication key on a key chain is
valid to be received.
accept-lifetime start-time month date year {duration seconds | end-time |
infinite}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the accept-lifetime configuration for an
authentication key:
no accept-lifetime start-time month date year
Command Type
Router command.
start-time Specifies the time of day the authentication key will begin to
be valid to be received. Valid input is
hours:minutes:seconds (hh:mm:ss)
month Specifies the month the authentication key will begin to be
valid to be received. Valid input is the first three letters of
the month.
date Specifies the day of the month the authentication key will
begin to be valid to be received. Valid values, depending on
the length of the month, are 1 - 31.
year Specifies the year the authentication key will begin to be
valid to be received. Valid input is four digits up to 2035.
duration seconds Length of time (in seconds) the key is valid to be received.
Valid values are 1 - 4294967295.
end-time Specifies the hours, minutes and seconds (hh:mm:ss) and
the month, date and year from the start-time the key is valid
to be received.
infinite Specifies that the key is valid to be received from the
start-time on.
To Next Page
Loading...
