Routing Protocol Configuration Command Set
Configuring RIP
13-24 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.2.17 ip rip disable-triggered-updates
Use this command to prevent RIP from sending triggered updates. Triggered updates are sent when
there is a change in the network and a new route with a lower metric is learned, or an old route is
lost. This command stops or starts the interface from sending these triggered updates. By default
triggered updates are enabled on a RIP interface.
ip rip disable-triggered-updates
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command allows RIP to respond to a request for a triggered
update:
no ip rip disable-triggered-updates
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to prevent RIP from responding to a request for triggered updates on
VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip disable-triggered-updates
To Next Page
Loading...
