Routing Protocol Configuration Command Set
Configuring OSPF
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-57
Command Syntax of the “no” Form
The “no” form of this command clears redistribution parameters:
no redistribute {connected | rip | static}
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
• If metric value is not specified, 0 will be applied.
• If type value is not specified, type 2 (external route) will be applied.
• If subnets is not specified, only non-subnetted routes will be redistributed.
• If route-map is not specified, none will be applied.
• If tag is not specified, none will be applied.
Example
This example shows how to distribute external type 2 RIP routing information from
non-subnetted routes in OSPF updates:
Matrix>Router1(config)#router ospf
Matrix>Router1(config-router)#redistribute rip
To Next Page
Loading...
