Routing Protocol Configuration Command Set
Configuring OSPF
13-70 Matrix DFE-Platinum and Diamond Series Configuration Guide
Table 13-5 provides an explanation of the command output.
Table 13-5 show ip ospf neighbor Output Details
Output What It Displays...
ID Neighbor’s router ID of the OSPF neighbor.
Pri Neighbor’s priority over this interface.
State Neighbor’s OSPF communication state.
Dead-Int Interval (in seconds) this router will wait without receiving a
Hello packet from a neighbor before declaring the neighbor
is down.
Address Neighbor’s IP address.
Interface Neighbor’s interface (VLAN).
To Next Page
Loading...
