Routing Protocol Configuration Command Set
Configuring VRRP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-95
13.2.6.4 priority
Use this command to set a priority value for a VRRP router.
priority vlan vlan-id vrid priority-value
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the VRRP priority configuration:
no priority vlan vlan-id vrid priority-value
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how set a VRRP priority of 200 on VLAN 1, VRID 1:
vlan vlan-id Specifies the number of the VLAN on which to configure
VRRP priority. This VLAN must be configured for IP
routing as described in Section 2.3.2.
vrid Specifies a unique Virtual Router ID (VRID) associated
with the routing interface. Valid values are from 1 to 255.
priority-value Specifies the VRRP priority value to associate with the
vrid. Valid values are from 1 to 254, with the highest value
setting the highest priority. Priority value of 255 is reserved
for the VRRP router that owns the IP address associated
with the virtual router. Priority 0 is reserved for signaling
that the master has stopped working and the backup router
must transition to master state.
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#priority vlan 1 1 200
To Next Page
Loading...
