Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14-110 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.8.8 set cep detection-id
Use this command to create a new H.323, Siemens, or SIP phone detection configuration group, or
enable, disable or remove an existing group.
set cep detection-id id {create | delete | disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create CEP detection group 1
:
NOTE: This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
id Specifies a CEP configuration group value. Valid values
are 1 - 2147483647.
create | delete |
disable | enable
Creates a new convergence end points detection
configuration group, or removes, disables or enables an
existing group. A group must first be created then enabled
to become operational.
Matrix>set cep detection-id 1 create
To Next Page
Loading...
