General Configuration Command Set
Resetting the Device
2-154 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.12.3 reset at
Use this command to schedule a system reset at a specific future time. This feature is useful for
loading a new boot image.
reset at hh:mm [mm/dd] [reason]
Syntax Description
Command Defaults
• If month and day are not specified, the reset will be scheduled for the first
occurrence of the specified time.
• If a reason is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to schedule a reset at 8 p.m. on October 12:
This example shows how to schedule a reset at a specific future time and include a reason for the
reset:
hh:mm Schedules the hour and minute of the reset (using the
24-hour system).
mm/dd (Optional) Schedules the month and day of the reset.
reason (Optional) Specifies a reason for the reset.
Matrix(rw)->reset at 20:00 10/12
Reset scheduled at 20:00:00, Sat Oct 12 2002
Proceed with scheduled reset? (y/n) [n]? y
Reset scheduled for 20:00:00, Sat Oct 12 2002 (in 1 day 5 hours 40 minutes
Matrix(rw)->reset at 20:00 10/12 Software upgrade to 6.1(1)
Reset scheduled at 20:00:00, Sat Oct 12 2002
Reset reason: Software upgrade to 6.1(1)
Proceed with scheduled reset? (y/n)
[n]? y
Reset scheduled for 20:00:00, Sat Oct 12 2002 (in 1 day 5 hours 40 minutes
To Next Page
Loading...
