Enterasys Matrix 2G4072-52 - Page 194

Preparing the Device for Router Mode
Enabling Router Configuration Modes
2-168 Matrix DFE-Platinum and Diamond Series Configuration Guide
Router
Configuration
Mode
Set IP protocol
parameters.
Type router and the
protocol name (and,
for OSPF, the
instance ID) from
Global or Interface
Configuration mode.
Matrix>Router1
(config-router)#
Key Chain
Configuration
Mode
Set protocol (RIP)
authentication key
parameters.
Type key chain and
the key chain name
from Router (RIP)
Configuration mode.
Matrix>Router1
(config-keychain)#
Key Chain Key
Configuration
Mode
Configure a specific
key within a RIP
authentication key
chain.
Type key
and the
key-id from Key
Chain Configuration
Mode.
Matrix>Router1
(config-keychain-key)#
Route Map
Configuration
Mode
Configure route
maps 1-99.
Type route-map, an
id-number, and
permit or deny from
Global Configuration
Mode.
Matrix>Router1
(config-route-map)#
Policy-Based
Routing
Configuration
Mode
Configure
policy-based
routing for route
maps 100-199.
Type route-map, an
id-number, and
permit or deny from
Global Configuration
Mode.
Matrix>Router1
(config-route-map-pbr)#
Server Load
Balancing (SLB)
Server Farm
Configuration
Mode
Configure an
LSNAT server
farm.
Type ip slb
serverfarm and the
serverfarmname
from Global
Configuration Mode.
Matrix>Router1
(config-slb-sfarm)#
Table 2-11 Router CLI Configuration Modes (Continued)
Use this mode... To... Access method... Resulting Prompt...