Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-54 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Usage
As described in the ANSI/TIA Standards document 1057, the Network Policy TLV is “intended for
use with applications that have specific real-time network policy requirements, such as interactive
voice and/or video services” and should be implemented only on direct links between network
connectivity devices and endpoint devices. Refer to the ANSI/TIA Standards document 1057 for
descriptions of the application types.
After you configure Network Policy TLVs, you must also configure the port to send the Network
Policy TLV with the set lldp port tx-tlv command.
vid vlan-id | dot1p (Optional) VLAN identifier for the port. The value of
vlan-id can range from 1 to 4094.
Use dot1p if the device is using priority tagged frames,
meaning that only the IEEE 802.1D priority level is
significant and the default PVID of the ingress port is
used.
cos cos-value (Optional) Specifies the Layer 2 priority to be used for
the application being configured. The value can range
from 0 to 7. A value of 0 represents use of the default
priority as defined in IEEE 802.1D.
dscp dscp-value (Optional) Specifies the DSCP value to be used to
provide Diffserv node behavior for the application being
configured. The value can range from 0 to 63. A value
of 0 represents use of the default DSCP value as defined
in RFC 2475.
port-string Specifies the port or range of ports to be affected.
To Next Page
Loading...
Need help?
General