Enterasys Matrix 2G4072-52 - Page 292

Port Configuration Command Set
Reviewing Port Status
4-32 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Defaults
If no options are specified, causes for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display operation status causes for ports ge.1.1 through 6. In this case,
port ge.1.6 is down due to a link loss:
lag (Optional) Displays ports dormant due to Link Aggregation
Group (LAG) membership. For more information on
configuring LAG, refer to Section 4.3.8.
Matrix(rw)->show port operstatuscause ge.1.1-6
+------------------------------+
| A L L D |
| D L F S I F O |
| M O L E N L P C T L |
| I S A L I O O O 1 A |
Port | N S P F T W L S X G |
----------+------------------------------+
ge.1.1 | . . . . . . . . . . |
ge.1.2 | . . . . . . . . . . |
ge.1.3 | . . . . . . . . . . |
ge.1.4 | . . . . . . . . . . |
ge.1.5 | . . . . . . . . . . |
ge.1.6 | . X . . . . . . . . |