Startup and General Configuration Summary
Factory Default Settings
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-7
Table 2-2 Default Device Settings for Router Mode Operation
Device Feature Default Setting
Access groups (IP
security)
None configured.
Access lists (IP
security)
None configured.
Area authentication
(OSPF)
Disabled.
Area default cost
(OSPF)
Set to 1.
Area NSSA (OSPF) None configured.
Area range (OSPF) None configured.
ARP table No permanent entries configured.
ARP timeout Set to 14,400 seconds.
Authentication key
(RIP and OSPF)
None configured.
Authentication mode
(RIP and OSPF)
None configured.
Dead interval (OSPF) Set to 40 seconds.
Disable triggered
updates (RIP)
Triggered updates allowed.
Distribute list (RIP) No filters applied.
DoS prevention Disabled.
DVMRP Disabled. Metric set to 1.
Hello interval (OSPF) Set to 10 seconds for broadcast and point-to-point networks. Set to
30 seconds for non-broadcast and point-to-multipoint networks.
ICMP Enabled for echo-reply and mask-reply modes.
To Next Page
Loading...
Need help?
General