Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-71
Command Defaults
• If not specified, information about all link flap detection settings will be
displayed.
• If port-string is not specified, information for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display the global status of the link trap detection function:
This example shows how to display ports disabled by link flap detection due to a violation:
This example shows how to display the link flap parameters table:
violations Displays the number of link flap violations since the last
reset.
port-string (Optional) Displays information for specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix(rw)->show linkflap globalstate
Linkflap feature globally disabled
Matrix(rw)->show linkflap downports
Ports currently held DOWN for Linkflap violations:
None.
Matrix(rw)->show linkflap parameters
Linkflap Port Settable Parameter Table (X means error occurred)
Port LF Status Actions Threshold Interval Downtime
-------- --------- ------- ---------- ---------- ----------
ge.1.1 disabled ....... 10 5 300
ge.1.2 enabled D..S..T 3 5 300
ge.1.3 disabled ...S..T 10 5 300
To Next Page
Loading...
