Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
4-72 Matrix DFE-Platinum and Diamond Series Configuration Guide
Table 4-5 provides an explanation of the show linkflap parameters command
output.
This example shows how to display the link flap metrics table:
Table 4-6 provides an explanation of the show linkflap metrics command output.
Table 4-5 show linkflap parameters Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible
port-string values, refer to Section 4.1.1.
LF Status Link flap enabled state.
Actions Actions to be taken if the port violates allowed link flap
behavior. D = disabled, S = Syslog entry will be generated,
T= SNMP trap will be generated.
Threshold Number of link down transitions necessary to trigger the link
flap action.
Interval Time interval (in seconds) for accumulating link down
transitions.
Downtime Interval (in seconds) port(s) will be held down after a link
flap violation
Matrix(rw)->show linkflap metrics
Port LinkStatus CurrentCount TotalCount TimeElapsed Violations
-------- ----------- ------------ ---------- ----------- -------------
ge.1.1 operational 0 0 241437 0
ge.1.2 disabled 4 15 147 5
ge.1.3 operational 3 3 241402 0
Table 4-6 show linkflap metrics Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible
port-string values, refer to Section 4.1.1.
LinkStatus Link status according to the link flap function.
CurrentCount Link down count accruing toward the link flap threshold.
TotalCount Number of link downs since system start,
To Next Page
Loading...
