General Configuration Command Set
Managing the Management Authentication Notification MIB
2-38 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.2.2 set mgmt-auth-notify
Use this command to either enable or disable the Management Authentication Notification MIB.
By selecting the optional Management access type, a user can specifically enable or disable a single
access type, multiple access types or all of the access types. The default setting is that all
Management Authentication Notification types are enabled.
set mgmt-auth-notify {enable | disable}{console | ssh | telnet | web}
Syntax Description
Command Defaults
If none of the optional Management Authentication Access types are entered, than
all authentications types listed above will either be enabled or disabled.
Command Type
Switch command.
Command Mode
Read-Write.
NOTE: Insure that SNMP is correctly configured on the DFE in order to send these
notifications, refer to the following chapter for configuring SNMP
(Chapter 5).
enable Enable selected or all notifications.
disable Disable selected or all notifications.
console (Optional) console authentications
ssh (Optional) ssh authentications
telnet (Optional) telnet authentications
web (Optional) web authentications
To Next Page
Loading...
