General Configuration Command Set
Managing the Management Authentication Notification MIB
2-40 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.2.3 clear mgmt-auth-notify
Use this command to set the current setting for the Management Authentication Notification access
types to the default setting of enabled.
clear mgmt-auth-notify
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
NOTE: Ensure that SNMP is correctly configured on the DFE in order to send these
notifications. Refer to
Chapter 5 for SNMP configuration information.
To Next Page
Loading...
