Enterasys Matrix 2G4072-52 - Page 669

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-25
ipxsource Displays source IPX address rules.
ipxdestsocket Displays destination IPX socket rules.
ipxsourcesocket Displays source IPX socket rules.
ipxtype Displays IPX packet type rules.
llcDsapSsap Displays 802.3 DSAP/SSAP rules.
macdest Displays MAC destination address rules.
macsource Displays MAC source address rules.
port Displays port related rules.
tci Displays Tag Control Information rules.
tcpdestportip Displays TCP destination port rules.
tcpsourceportip Displays TCP source port rules.
udpdestport Displays UDP destination port rules.
udpsourceportip Displays UDP source port rules.
vlantag Displays VLAN tag rules.
data (Not required for ipfrag classification.) Displays rules for a
predefined classifier. This value is dependent on the
classification type entered. Refer to Table 8-3 for valid
values for each classification type.
mask mask (Optional) Displays rules for a specific data mask. Refer to
Table 8-3 for valid values for each classification type and
data value.
port-string
port-string
(Optional) Displays rules related to a specific ingress port.
rule-status active
| not-in-service |
not-ready
(Optional) Displays rules related to a specific rules status.
storage-type
non-volatile |
volatile
(Optional) Displays rules configured for either non-volatile
or volatile storage.
vlan vlan (Optional) Displays rules for a specific VLAN ID.