Enterasys Matrix 2G4072-52 - Page 738

Policy Classification Configuration Command Set
Setting the Status of Dynamically Assigned Policy Profiles
8-94 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.4.1 show policy dynamic
Use this command to display the status of dynamically assigned policy profile options.
show policy dynamic {[syslog-default] [trap-default]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of Syslog message sending when a dynamic rule is
applied:
syslog-default Shows the status of automatically sending Syslog messages
when a dynamic rule is applied.
trap-default Shows the status of automatically sending SNMP trap
messages when a dynamic rule is applied.
Matrix(rw)->show policy dynamic syslog-default
Syslog-default is ENABLED