Enterasys Matrix 2G4072-52 - Page 739

Policy Classification Configuration Command Set
Setting the Status of Dynamically Assigned Policy Profiles
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-95
8.3.4.2 set policy dynamic
Use this command to set the status of dynamically assigned policy profile options.
set policy dynamic [syslog-default {enable | disable}] [trap-default {enable |
disable}]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable the sending of Syslog messages when a dynamic rule is applied:
syslog-default
enable | disable
Enables or disables the sending of Syslog messages when a
dynamic rule is applied.
trap-default
enable | disable
Enables or disables the sending of SNMP trap messages
when a dynamic rule is applied.
Matrix(rw)->set policy dynamic syslog-default disable