Enterasys Matrix 2G4072-52 - Page 740

Policy Classification Configuration Command Set
Setting the Status of Dynamically Assigned Policy Profiles
8-96 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.4.3 clear policy dynamic
Use this command to reset the status of dynamically assigned policy profiles back to defaults.
clear policy dynamic {[override] [syslog-default] [trap-default]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the sending of Syslog messages when a dynamic rule is applied
to enabled:
override Resets the status of the ability for administratively assigned
profile rules to override dynamically assigned rules to
enabled.
syslog-default Resets the status of the sending of Syslog messages when a
dynamic rule is applied to enabled.
trap-default Resets the status of the sending of SNMP trap messages
when a dynamic rule is applied to enabled.
Matrix(rw)->clear policy dynamic syslog-default