Logging And Network Management Command Set
Configuring System Logging
11-8 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Defaults
• If ip-addr is not specified, an entry in the Syslog server table will be created
with the specified index number and a message will display indicating that no
IP address has been assigned.
• If not specified, facility, severity and port will be set to defaults configured
with the set logging default command (Section 11.2.1.6.).
• If state is not specified, the server will not be enabled or disabled.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This command shows how to enable a Syslog server configuration for index 1, IP address
134.141.89.113, facility local4, severity level 3 on port 514:
Matrix(rw)->set logging server 1 ip-addr 134.141.89.113 facility
local4 severity 3 port 514 state enable
To Next Page
Loading...
