Enterasys Matrix 2G4072-52 - Page 8

Contents
vi Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2 General Configuration Command Set...........................................................2-24
2.2.1 Setting User Accounts and Passwords.........................................2-24
2.2.2 Managing the Management Authentication Notification MIB ........2-36
2.2.3 Setting Basic Device Properties....................................................2-42
2.2.4 Activating Licensed Features........................................................2-91
2.2.5 Configuring Power over Ethernet (PoE)........................................2-95
2.2.6 Downloading a New Firmware Image.........................................2-116
2.2.7 Reviewing and Selecting a Boot Firmware Image ......................2-119
2.2.8 Starting and Configuring Telnet ..................................................2-122
2.2.9 Managing Configuration and Image Files ...................................2-129
2.2.10 Enabling or Disabling the Path MTU Discovery Protocol............2-143
2.2.11 Pausing, Clearing and Closing the CLI.......................................2-147
2.2.12 Resetting the Device...................................................................2-150
2.2.13 Gathering Technical Support Information ...................................2-157
2.3 Preparing the Device for Router Mode........................................................2-160
2.3.1 Pre-Routing Configuration Tasks................................................2-160
2.3.2 Reviewing and Configuring Routing Modules.............................2-162
2.3.3 Enabling Router Configuration Modes........................................2-167
3
CONFIGURING DISCOVERY PROTOCOLS
3.1 Overview .........................................................................................................3-1
3.2 Discovery Protocols Command Set ................................................................3-1
3.2.1 Displaying Neighbors......................................................................3-1
3.2.2 Enterasys Discovery Protocol.........................................................3-4
3.2.3 Cisco Discovery Protocol..............................................................3-12
3.2.4 Link Layer Discovery Protocol and LLDP-MED ............................3-25
4
PORT CONFIGURATION
4.1 Port Configuration Summary...........................................................................4-1
4.1.1 Port String Syntax Used in the CLI .................................................4-2
4.2 Process Overview: Port Configuration ............................................................4-5
4.3 Port Configuration Command Set ...................................................................4-6
4.3.1 Setting Console Port Properties......................................................4-6
4.3.2 Reviewing Port Status...................................................................4-24
4.3.3 Disabling / Enabling and Naming Ports ........................................4-34
4.3.4 Setting Speed and Duplex Mode ..................................................4-42
4.3.5 Enabling / Disabling Jumbo Frame Support .................................4-47
4.3.6 Setting Auto-Negotiation and Advertised Ability ...........................4-51
4.3.7 Setting Flow Control......................................................................4-63
4.3.8 Configuring Link Traps and Link Flap Detection...........................4-67
4.3.9 Configuring Broadcast Suppression .............................................4-83