Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-107
Command Defaults
• If not specified, waittime will be set to 5 seconds.
• If not specified, first-ttl will be set to 1 second.
• If not specified, max-ttl will be set to 30 seconds.
• If not specified, port will be set to 33434.
• If not specified, nqueries will be set to 3.
• If -r is not specified, normal host routing tables will be used.
• If -d is not specified, the debug socket option will not be used.
• If not specified, tos will be set to 0.
• If -F is not specified, the ‘don’t fragment’ bit will not be applied.
• If gateway is not specified, none will be applied.
• If -I is not specified, UDP datagrams will be used.
• If -v is not specified, summary output will be displayed.
• If -x is not specified, checksums will be calculated.
Command Type
Switch command.
Command Mode
Read-Only.
-x (Optional) Prevents traceroute from calculating
checksums.
host Specifies the host to which the route of an IP packet will
be traced.
packetlen (Optional) Specifies the length of the probe packet.
To Next Page
Loading...
