IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12-134 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.9.18 client-identifier
Use this command to enable DHCP host configuration mode and associate a client class with a
DHCP client.
client-identifier mac-address [client-class name]
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command deletes a client identifier:
no client-identifier unique-identifier
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
If client-class is not specified, none will be assigned.
Example
This example shows how to assign client MAC address 00.01f4.0127 within “clientclass1”:
mac-address Specifies the client’s MAC address.
client-class name (Optional) Specifies the class to which this client will be
assigned. Must be configured using the client-class name as
described in Section 12.2.9.17.
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#client-identifier 0100.01f4.0127 client-class
clientclass1
To Next Page
Loading...
