IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-135
12.2.9.19 client-name
Use this command to assign a name to a DHCP client.
client-name name [client-class name]
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command deletes a client name:
no client-name name
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
If client-class is not specified, none will be assigned.
Example
This example shows how to assign “soho1” as a client name in “clientclass1”:
name Specifies a name for a DHCP client.
NOTE: The client name should not include the
domain name.
client-class name (Optional) Specifies the class to which this client will be
assigned. Must be configured using the client-class name as
described in Section 12.2.9.17.
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#client-name soho1 client-class clientclass1
To Next Page
Loading...
