line console baudrate
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
65
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
LINE CONSOLE BAUDRATE
line console baudrate {115200|19200|2400|38400|4800|57600|9600}
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure the baud rate.
PARAMETERS
DEFAULT VALUE
Default is 9600 baud.
EXAMPLE
ALU(config)# line console baudrate 19200
LINE CONSOLE EXEC-TIMEOUT
line console exec-timeout <0-35791> [<0-60>]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure the timeout (in minutes or seconds) for console session. The console
CLI session closes if it is idle for the specified time.
A zero input specifies that the console CLI should never exit when left idle.
PARAMETERS
DEFAULT VALUE
The default time-out is 20 minutes.
EXAMPLE
ALU(config)#line console exec-timeout 0
ALU(config)#line console exec-timeout 45 15
Parameter Description
2400|4800|9600|19200|38400|
57600|115200
The baud rate.
Parameter Description
0-35791 Time-out in minutes.
0-60 Time-out in seconds.