Alcatel-Lucent OmniAccess 5740 - Clear Mac-Address-Table Dynamic; Duplex

clear mac-address-table dynamic
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
185
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CLEAR MAC-ADDRESS-TABLE DYNAMIC
clear mac-address-table Dynamic [slot <slot-number>|vlan <1-
4094>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command clears the mac-address-table learnt by the system.
PARAMETERS
EXAMPLE
ALU# clear mac-address-table Dynamic
DUPLEX
duplex {auto|full|half}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
configures duplex operation on an interface.
PARAMETERS
None.
DEFAULT VALUE
The default Duplex mode is “auto”.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if switchport1/0)# duplex full
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
slot-number Specifies the slot number of the
interface.
1-4094 User configured VLAN-ID or 1 if it is a
default VLAN-ID.