Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

tunnel destination
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
871
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
TUNNEL DESTINATION
tunnel destination {<ip-address>|<FQDN>}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the destination IP address or fully qualified domain name (FQDN) of the
tunnel at the remote end.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if Tunnel7)# tunnel destination 10.1.0.5
ALU(config-if Tunnel7)# tunnel destination mysmb.dyndns.org
RELEASE HISTORY
Release 3.0: Parameter “FQDN” was introduced.
Parameter Description
ip-address Destination IP address of the tunnel at
the remote end.
FQDN Fully qualified domain name of the
tunnel at the remote end.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English