Alcatel-Lucent OmniAccess 5740 - Ip Dhcp Pool

DHCP (Dynamic Host Configuration Protocol) Server
Left running head:
Chapter name (automatic)
944
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP DHCP POOL
ip dhcp pool <pool-name> [vrf <vrf-name>]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure a DHCP pool. This enters the DHCP pool sub-configuration mode.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# ip dhcp pool p1 vrf alu-vrf
ALU(config-dhcp-pool-p1)#
RELEASE HISTORY
Release 2.3: Parameter [vrf <vrf-name>] was added.
Parameter Description
pool-name Name of the pool. The pool name should
be unique across the system.
vrf-name If the VRF name is specified, it
configures the DHCP pool in the
specified VRF. If the VRF is not
specified, the pool is configured for the
Default VRF.