Alcatel-Lucent OmniAccess 5740 - Pppoe Retry-Timer

pppoe retry-timer
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
319
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
PPPOE RETRY-TIMER
pppoe retry-timer <0-300>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the initial timer for re-transmission of PPPoE PADI/ PADR packets in the
absence of a PADO/PADS from a server.
Wait period doubles between successive PADIs. However, after three
unanswered PADIs, wait period is reset to configured retry-timer.
If the retry-timer value is set to ‘0’, PPPoE client sends only one PADI/PADR. With
max-retry value ‘0’ (default), PPPoE client keeps sending PADIs till a PADO is
received.
PARAMETERS
DEFAULT VALUE
The default retry-timer value is 10 seconds.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe retry-timer 15
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
0-300 Denotes the initial timer for re-
transmission of PPPoE PADI (or PADR)
packets.