Alcatel-Lucent OmniAccess 5740 - Mode

mode
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
869
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
MODE
mode {gre|ipsec|multipoint-gre}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to set the mode on tunnel interface.
PARAMETERS
DEFAULT VALUE
By default, tunnel is configured in the GRE mode.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if Tunnel7)# mode gre
RELEASE HISTORY
Release 3.0: Parameter “multipoint-gre” was introduced.
Parameter Description
gre Sets the tunnel in GRE mode.
ipsec Sets the tunnel in IPsec mode.
multipoint-gre Sets the tunnel in Multipoint GRE mode.