Alcatel-Lucent OmniAccess 5740 - No Nhrp; No Ip Nhrp; No Map; No Network-ID

IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
820
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO NHRP
no nhrp <object-name>
This command is entered in the Interface Configuration Mode. This command is
used to detach a NHRP object attached to the interface.
Note: You cannot delete a NHRP object that is applied to the interface. To delete, first
detach a NHRP object from the interface.
NO IP NHRP
no ip nhrp <object-name>
This command is entered in the Configuration Mode. This command is used to
delete a NHRP object.
Note: You cannot delete a NHRP object if it is attached to any interface. First detach it from
the interface and then delete it.
NO MAP
no map {<nhs-ip-address> <nbma-address>|multicast dynamic}
This command is entered in the Client Object Configuration Mode. This command
is used to delete the static map entry.
NO NETWORK-ID
no network-id
This command is entered in the Client Object Configuration Mode. This command
is used to delete the configured network identifier.
NO NHS
no nhs <ip-address>
This command is entered in the Client Object Configuration Mode. This command
is used to delete the IP address of the NHS from a NHRP object.
NO REGISTRATION TIMEOUT
no registration timeout
This command is entered in the Client Object Configuration Mode. The “no”
command resets the registration timeout to its default, i.e., every two-third of the
NHRP holdtime.