Alcatel-Lucent OmniAccess 5740 - Show Ip Rip Statistics

show ip rip statistics
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
485
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SHOW IP RIP STATISTICS
show ip rip statistics [vrf <vrf-name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the RIP statistics including both the global and interface
statistics.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU# show ip rip statistics
RIP Global Statistics
---------------------
Route Changes Route Queries Rx Bad Msgs Routes Learnt Routes Held down
1 0 19 1 0
ALU#
RIP Interface Statistics
------------------------
Interface RIPv1 RIPv2
GigabitEthernet3/0 Routes learned 0 Updates sent 0 11
Bad msgs received 14 Trig Updates sent 0 2
Auth failures 0 Responses sent 0 0
*Unicast tx failure 0 Routes advertised 0 3
Bcast tx failures 0 Updates received 0 40
Mcast tx failures 0 Requests received 0 0
Bad Rtes received 0 0
GigabitEthernet3/1 Routes learned 1 Updates sent 0 8
Bad msgs received 5 Trig Updates sent 0 0
Auth failures 0 Responses sent 0 0
*Unicast tx failure 0 Routes advertised 0 1
Bcast tx failures 0 Updates received 0 3
Mcast tx failures 0 Requests received 0 0
Bad Rtes received 0 0
ALU#
RELEASE HISTORY
Release 2.3: Parameter [vrf <vrf-name>] was added.
Parameter Description
vrf-name
Name of the VRF.