Multilink Point to Point Protocol
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
323
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CHAPTER 17 MULTILINK POINT TO POINT PROTOCOL
This chapter documents the Command Line Interface (CLI) commands for the
Multilink Point-to-Point Protocol (MLPPP). These commands are used to
configure Multilink PPP encapsulation on a T1 or E1 interface or a Serial (V.35/
X.21) interface.
This chapter includes table of parameters, default values, and configuration
examples for MLPPP configurations as quick-start and reference information. In
this chapter, all the commands are described in alphabetical order. For more
detailed information about using and configuring the Multilink Point-to-Point
Protocol, refer to the OmniAccess 5740 Unified Services Gateway CLI
Configuration Guide.
To Next Page
Loading...
Need help?
General
