Alcatel-Lucent OmniAccess 5740 - Eth-Cfm 2 Dmtest

eth-cfm 2dmtest
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
347
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
ETH-CFM 2DMTEST
eth-cfm 2DMtest <mac-address> mep <1-8191> domain <0-65535>
association <0-65535> [priority <0-7>]
DESCRIPTION
This is entered in the OAM Configuration Mode. This command is used to initiate
a ETH-CFM two-way delay test.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-oam)# eth-cfm 2DMtest 1111.1111.1111 mep 10 domain 1
association 10 priority 2
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
mac-address MAC address given on the interface.
1-8191 An integer, unique over a given MA,
identifying a specific MEP.
0-65535 An unique integer identifying a specific
maintenance domain.
0-65535 An unique integer identifying a specific
maintenance association.
0-7 Value set for CCM and LTMs on a MEP.