Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Open Shortest Path First
Left running head:
Chapter name (automatic)
592
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW IP OSPF INTERFACE-PROCESS
show ip ospf interface-process [<interface-name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the interface-process table.
PARAMETERS
EXAMPLE
ALU(config)# show ip ospf interface-process
Interface-Process Table:
-------------------------------------------------------
Interface Attached Process Waiting Process
GigabitEthernet3/0 20
-
GigabitEthernet3/0
20 -
loopback 9 - -
loopback1 - -
Transmit Delay Interface transmit delay, interface state,
and router priority.
Designated Router Designated router ID and respective
interface IP address.
Backup Designated Router Backup designated router ID and
respective interface IP address.
Timer intervals configured Configuration of timer intervals.
Hello Number of seconds until next hello
packet is sent out this interface.
Neighbor Count Count of neighbors and list of adjacent
neighbors on an interface.
Message Digest Authentication Type of authentication enabled on an
interface.
Parameter Description
interface-name Interface name with its slot and port
number.
Parameter Description

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English